From which angles can you judge the quality of the laser cutting machine?
2022-02-11248

For new customers, when they inspect the laser cutting machine for the first time, they will require on-site proofing.

 

 

In addition to the cutting speed, it is more important to look at the overall quality of the cutting. So from which dimensions do you measure the quality of a laser cutting machine? The following Bond Laser editor will give you a detailed introduction

 

roughness

 

The cross section of the laser cutting machine will form vertical lines, and the depth of the lines determines the roughness of the cutting surface.

 

The shallower the lines, the smoother the cutting section. Roughness not only affects the appearance of the finished product, but also affects the degree of friction.

 

In most cases, it is necessary to reduce the texture depth of the cutting section. The smoother the surface, the better the effect.

 

Verticality

 

If the thickness of the cut sheet exceeds 10mm, the perpendicularity of the cutting edge becomes important.

 

During the cutting process, the laser head moves from far to near and from top to bottom. The beam of the focus becomes scattered when it is farther away.

 

The closer it moves to the target, the more concentrated the beam, and a vertical beam will be generated in the middle. deviation, and the smaller the vertical deviation, the better the machine performance

 

Cut lines and burrs

 

As we all know, the advantage of laser cutting machine compared with other processing equipment is that the cutting burr is small, the efficiency is fast, and the precision is high.

 

When the laser cutting machine processes the thick plate, the molten metal residue will not appear on the vertical cutting surface, but will appear diagonally below, which causes the gas to blow away the slag when it blows the slag.

 

Cut dross and burrs. In order to correct this problem, it is generally necessary to reduce the speed at the end of the cutting, so as to reduce the slag and burrs as much as possible. Therefore, when cutting medium and thick plates, the less burrs and slag, the better the machine quality!

 

The above are some points of judgment on the quality of laser cutting machines that Bond Laser has sorted out for you. I hope users will remember these points when purchasing a laser cutting machine.

 

Of course, we should examine the culture of a company, after-sales service, and service are also the top priorities.